HÃ¥kan Foldefors Posted April 12, 2014 Report Share Posted April 12, 2014 For clutchless gear cut you would use a load cell on the gear stick that has a 0-5v output. So it would make the install alot simpler without external electronics if you could use analog in with a trig voltage as gear cut control channel. http://www.srpcontrol.com/product-p/ka-gst.htm Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted April 14, 2014 Report Share Posted April 14, 2014 Hi, Do you have a spare digital input available. If so set that digital input function up as GEAR CUT. Pull up resistor OFF On Level =  High Active Edge = Rising. Go down to MOTORSPORTS TAB and open the GEAR CUT CONTROL TAB. The rest of your setup is done here and the GEAR CUT EDIT TABLE. Regards Dave. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.