Jump to content

LinkPlus G2, removing 6 terminal ISC controller


Jay Storm

Recommended Posts

Upon removing the ISC board, I found a resistor (R89) visibly discolored from heat. It pulled the same resistance as the others in the bank around it (2.35ohm) so I'm not too concerned at this point. What does concern me is the onboard MAP sensor. I thought that the G2 didn't have them. Chip is LPV10 - 160603 and up to this point, I have been assigning wires using the G2 pin diagram. Any insight? Thanks in advance, Jay Storm

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...