Jump to content

Is a failsafe boost cut based on AFRs possible w/ Storm?


Recommended Posts

Posted

Hello,

With the Storm, is it possible to configure a failsafe where if boost pressure is greater than a certain PSI and AFR is greater than a certain reading, specific actions can be taken?  For instance, cut ignition, deactivate WG solenoid to cut boost, etc.

Thank you

 

Posted

Hi Dave,

Thanks for the info.  I looked in to the GP but I'm not quite clear on how it'd get set up.  I'm thinking I'd assign one axis to MAP and the other to AFR.  Then in each cell I'll enter the RPM at which cut would occur.

Am I on the right track?

 

Hi MethOD,

Yes you can create these in general purpose limiters.

Regards

Dave.

Posted

Correct. Any figure that is lower that the normal RPM limit will then act as a limit for the give MAP and AFR reading.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...