ericsiewkk Posted July 23, 2016 Report Share Posted July 23, 2016 (edited) i have installed atom on obd1 b16a civic by wire in. car running fine on stock distributor ignition but we cannot get it running with individual coil on plug. it get back fire from intake sounds like wrong firing sequence.i have checked every setting and make sure it is correct. what could possibly goes wrong?ignition mode: direct sparkspark edge: fallingignition coil used is honda k20a wired as follow.ignition output 1 - cylinder 1ignition output 2 - cylinder 2ignition output 3 - cylinder 3ignition output 4 - cylinder 4 Edited July 23, 2016 by ericsiewkk Quote Link to comment Share on other sites More sharing options...
integrale8v Posted July 23, 2016 Report Share Posted July 23, 2016 What kind of cam/sync trigger do you have? is this set up correctly? Quote Link to comment Share on other sites More sharing options...
jonnyt80 Posted July 23, 2016 Report Share Posted July 23, 2016 You may need to wire it as per firing order but you would need to confirm the wiring Quote Link to comment Share on other sites More sharing options...
ericsiewkk Posted July 24, 2016 Author Report Share Posted July 24, 2016 What kind of cam/sync trigger do you have? is this set up correctly?stock distributor as trigger. The car running fine on stock ignition. You may need to wire it as per firing order but you would need to confirm the wiringwire as per firing order? I am following the wiring manual. Can anyone reconfirm? Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 24, 2016 Report Share Posted July 24, 2016 wire as per firing order? I am following the wiring manual. Can anyone reconfirm?No it should not be wired in firing order. 1>1, 2>2, etc as you already have it is correct. You need to put a timing light on it now to check your trigger offset. The reason is before when it had a distributor the offset could be out by 180 or 360 deg and it would still run fine, now with COP it will only run when you have that setting correct. Simon 1 Quote Link to comment Share on other sites More sharing options...
Tarmizi Ramly Posted September 15, 2016 Report Share Posted September 15, 2016 Laju Quote Link to comment Share on other sites More sharing options...
L8rb0l Posted March 25, 2018 Report Share Posted March 25, 2018 Which sensors inside the distributor did you wire up as trigger and sync? And did you find the solution to your issue here? Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 26, 2018 Report Share Posted March 26, 2018 8 hours ago, L8rb0l said: Which sensors inside the distributor did you wire up as trigger and sync? And did you find the solution to your issue here? This was 2 years ago so I should hope he's got it running by now. If you want some help with your setup then it would probably be best to start a new thread so we get info more relevant to your problem. L8rb0l 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.