Jump to content

Recommended Posts

Hey Guys,

I recently finished swapping a VR6 engine into my S4 and was able to successfully start and run the engine. While I was going through my second heat cycle and getting ready to drive the car out of the garage i noticed a rear main leak which brought the project to a temporary stop. I am getting ready to pull the engine now to fix the leak and wanted to reach out to the community to see if anyone had a base-map for a VR6 engine. although my engine was running i noticed my ignition table seemed to advancing the spark too much for its given ECT (in the range of 20Deg BTDC) causing a high idle, poor reving, and bad throttle response. I am sure I can adjust the ignition tables (and others) to get it to work but I was hoping to bypass the unwanted run/idle time associated with tuning these basic parameters. Ultimately i want to fix my oil leak, start it up, and break in my engine with a decent chance of success and not have to worry about backfiring, nock, poor driveability etc. 

Thanks!

     

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...