Houseoftouge Posted December 30, 2016 Report Share Posted December 30, 2016 Recently installed G4+ Storm ECU on an RB25 neo swapped nissan patrol.Started up and ran beautifully on a base map for about a week. Put it on the lift for a wheel alignment and went to drive it off and it wont start.In PClink there is no rpm signal, assumed Crank angle sensor and replaced it, no lock.The wiring seems to be fine and has continuity to the ecu, good sensor ground and is getting voltage to the sensor.Is there something obvious that could cause the link to lose trigger signal or not recognize trigger signal after having been running perfectly previously?Thanks,Sam. Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 30, 2016 Report Share Posted December 30, 2016 Can you do a PC log of it cranking for a few seconds and post that and your map here. Quote Link to comment Share on other sites More sharing options...
Houseoftouge Posted January 4, 2017 Author Report Share Posted January 4, 2017 Will get a log done tonight and Upload it.For the moment I have a signal at the ecu plug when cranking on both triggers.ECU is definitely unlocked.Using trigger scope I get nothing registering at all. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.