G4 in 180sx

[Bellto]

recently purchased a link g4 plugin for s13/180sx ca18det.

Car runs sweet on stock ecu, installed link g4 and it doesnt fire on 4th cylindar.

 

Injector seems to be firing, has spark and cconpression. Has power and pulse at injector so its definitley firing

 

Other 3 cylindars seem to be sweet, just wont fire on 4th. Is there a drama with trigger setup perhaps?

 

Appeiciate any help

[Adamw]

First make sure the switches/jumpers are set up per the help file:

 

Next do the ECCS sync and base timing cal:

 

[Bellto]

Done and done. no dice

[Adamw]

post your .pcl file.

[Simon]

You can also use the ignition test function to check each cylinder 1 by one.

This will also confirm if the jumper settings are correct.

[Bellto]

Got it sorted, bad connection in coil loom. Fired while coil was out but didnt when it was installed. All good now