Jump to content

3d table for closed loop lambda compensation


Davidv
 Share

Recommended Posts

Hey, 

Lately I have been experimenting with having closed loop lambda turned on under all conditions.
From recent experiences having seen Motec M1 ECUs do this effectively I thought I'd give it a go. 
And it works well, even at WOT and high RPM.

However it would be nice to be able to set a finer level of control over how much it can add or remove. 
For example under cruising conditions I might be completely happy for the ECU to add or remove 40% fuel.
But at WOT, it would be nice if I could specify only say 10% change and enrichment only so it's never going to run leaner than the tune specifies. So if there is a sensor fault, it's not going to nuke the engine.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...