02emichan Posted September 9, 2017 Report Share Posted September 9, 2017 (edited) hi I have a link g4+ Subaru v5-6 and when I setup launch control it limits to the set rpm but won't retard the ignition it just uses the ignition set in the ignition table ? Log 2017-09-10 2;09;40 pm.llg mike silver.pclr Edited September 10, 2017 by 02emichan Quote Link to comment Share on other sites More sharing options...
Ducie54 Posted September 9, 2017 Report Share Posted September 9, 2017 Posting a map and a log file of the issue will always help diagnose the problem faster. Adamw 1 Quote Link to comment Share on other sites More sharing options...
02emichan Posted September 10, 2017 Author Report Share Posted September 10, 2017 uploaded needed files Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 11, 2017 Report Share Posted September 11, 2017 It is because you have your Ignition trim activation RPM set to the same as your Launch RPM (3000RPM). So you have the launch limiter set to keep the engine below 3000RPM but you have set your ignition trim to only become active above 3000RPM. The ignition trim would typically be set to activate 500-1000RPM earlier than the limiter. Quote Link to comment Share on other sites More sharing options...
02emichan Posted September 11, 2017 Author Report Share Posted September 11, 2017 thank you for your help all sorted now Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.