Jump to content

Toyota 20v . Trigger wheel position pls help !!!!


Recommended Posts

1. I using the 60-2 trigger wheel. The crank sensor is 7afe ( 3 wire ) . Black - earth , red - 5v or 8v ??? . White - trigger 1. the sensor is hall sensor???

2. (1st pic )the position of the trigger wheel & the sensor is correct or not . 11 teeth face the crank sensor, is tdc . The gab sensor and teeth is 5mm.Pls guide me . Thx .

3. Trigger wheel size tooth height 4mm, tooth width 2.5mm , distance between teeth 5 mm ,target thickness 5 mm , diameter out side 145 mm. Can I using this trigger wheel  ????

 

IMG20180524163111.jpg

IMG20180524163124.jpg

Link to post
Share on other sites
8 minutes ago, liang said:

1. I using the 60-2 trigger wheel. The crank sensor is 7afe ( 3 wire ) . Black - earth , red - 5v or 8v ??? . White - trigger 1. the sensor is hall sensor???

That sensor is a VR sensor and should only have two pins, ground and signal.  It looks like the black wire just grounds the shield to the mounting bracket.

 

8 minutes ago, liang said:

2. (1st pic )the position of the trigger wheel & the sensor is correct or not . 11 teeth face the crank sensor, is tdc . The gab sensor and teeth is 5mm.Pls guide me . Thx .

Gap position is fine at 11 teeth offset.  Air gap about 0.5mm at a guess.

 

10 minutes ago, liang said:

3. Trigger wheel size tooth height 4mm, tooth width 2.5mm , distance between teeth 5 mm ,target thickness 5 mm , diameter out side 145 mm. Can I using this trigger wheel  ????

Wheel design looks ok for this sensor to me.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...