PC-LINK does not communicate when AIM Dash MXS Strada and LINKECU are connected.

[azmak]

Hello everyone.
I am using AIM MXS Strada for the Nissan GTR LINK plug-in.
In this case, PC - LINK can not communicate.
If you disconnect the CAN connector of MXS Strada, PC - LINK can communicate.
This is inconvenient.
Is there a solution?

[JMP]

remove the additional wires from the CAN connector that goes to the ECU, so you only have the two CAN wires. 

[azmak]

まず、パソコンを「USB⇒」に接続しました。
AIMMXLを「CAN/RS232」に接続しました。
その場合、PC〜LINKECU〜AIMは同時に接続できませんでした。

AIMMXLを「CAN/RS232」に接続しました。
PCを「CAN2/OBD」に接続しましたが、通信できませんでした。

正しく接続する方法を教えてください。

 

 

[Adamw]

Extract the brown, grey & yellow wires out of the white plug (or snip the wires).  Only green and white are used for CAN.  Our you shorten the CAN DASH cable so that the RS232 wires are less than about 200mm long then it wont interfere with PC Comms.

Note this problem is because you are using the CANDASH cable which is not the correct cable for this (despite its poorly chosen name it also has the RS232 wires inside).   For a CAN only device connection we recommend using just the CANF plug and your own twisted pair wires for CAN H/CAN L.

 

[azmak]

LINK ECUに接続されているUSBケーブルは使用できませんか？
RS232ケーブルが必要ですか？

 

 

[Adamw]

No, Im talking about the cable connected to your dash, not the USB PC cable.  The USB PC cable is perfectly fine.  You need to change the wiring to the dash. 

[azmak]

I'll try.
I appreciate your guidance.
Thank you.