argyris Posted September 26, 2018 Report Share Posted September 26, 2018 My engines vaccum is at low levels because of the tall camshafts and i have some issues with the map sensor. The sensors values is very low (>=80 kph sensor reads but engines vaccum is lower) and i can’t fix the map of fuel. Where i can find to adjust it to take lower values or be more sensitive? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 26, 2018 Report Share Posted September 26, 2018 The MAP sensor needs to read accurately for the fuel calculation to work properly so you shouldnt go "fudging it" to make it more sensitive. Does it read the same as the BAP sensor with engine off? If you have a weak map signal then you will probably be better to use TP as the load axis on your fuel table Quote Link to comment Share on other sites More sharing options...
argyris Posted September 26, 2018 Author Report Share Posted September 26, 2018 how can i make it work with tp? Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted September 26, 2018 Report Share Posted September 26, 2018 change axis on tables Quote Link to comment Share on other sites More sharing options...
argyris Posted September 27, 2018 Author Report Share Posted September 27, 2018 Ok I made it and it works thanks you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.