AlexSavv Posted September 26, 2018 Report Share Posted September 26, 2018 Just another quick question from me as I start to lay out my loom. monsoon has 2 An Temp inputs, but I want to capture air, water and oil temp thefefore my question is... can you wire a temp sensor to another AN Input, not a temp specific one? thanks again! Alex Quote Link to comment Share on other sites More sharing options...
cj Posted September 26, 2018 Report Share Posted September 26, 2018 Yes you can, you just need to wire in a pullup resistor to 5v so that the AnVolt input sees between 0-5V depending on the resistance of the sensor. Simon 1 Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 27, 2018 Report Share Posted September 27, 2018 Quote Link to comment Share on other sites More sharing options...
AlexSavv Posted September 27, 2018 Author Report Share Posted September 27, 2018 Thought so, cheers Quote Link to comment Share on other sites More sharing options...
cwhite951 Posted July 30, 2023 Report Share Posted July 30, 2023 On 9/26/2018 at 11:31 PM, Adamw said: reviving an old topic - do you have an idea for a calibration curve for this NTC? I am in the middle of a project and it woudl be nice to have a decent starting point before I fire it up. its for a transmission temp sensor so not super critical. Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 30, 2023 Report Share Posted July 30, 2023 Use cal table 1-3 set up like below. I only done the first 3 cells but you get the idea. Quote Link to comment Share on other sites More sharing options...
cwhite951 Posted August 2, 2023 Report Share Posted August 2, 2023 thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.