Jump to content

Z33 g4+ nitrous control


Nikxjimenez

Recommended Posts

It’s a dry shot single fogger system. Pressure sensor is for bottle pressure. I should probably mention this is my first nitrous setup. I will not be the one tuning i just need to get everything ready for the tuner.

Also would assume the tuner could use the ecu as a window switch essentially. This is for a drift car so probably wouldn’t want it to be on/off. Correct me if I’m wrong!

Link to comment
Share on other sites

The Bottle pressure sensor is usually only used to activate the bottle heater when bottle press gets to low as far as I know.  Do you have a bottle heater and is that going to be ECU controlled?

 

Link to comment
Share on other sites

Yes you are correct. Bottle heater is controlled by pressure sensor. So literally all i need is the one wire from the solenoid relay to trigger the nitrous. I see in the installation manual aux 1-16. Would one of these work as a good source?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...