Leo Briones

Thanks brad, I appreciate your help and reply cheers!

It seems like 30 deg out mate, i removed the sensor and it measures 8430 ohms i'm in asia at the moment room temp is 25-30 deg, is there an available figures to match this sensor ? if i use Cal 3 would you be able to give me a guide please cheers mate thanks for your help I measure the resistance while it is out room temp about 25-30, the resistance is 8430 ohms and keeps going down when it gets cooler, have you got a similar sensor calibration figures to match, thanks for your help mate cheers!

Hi Guys, i just need a guide to set it up Idle on a link g4 storm, Im using a 4 wire stepper motor, like a GM stepper motor , It only runs better on open loop ISC, but runs bad on close loop, honestly setting is wrong, please find attached tune file and help me figure it out please, also do I really need to set a "ecu power hold" to function better or can I just use to set the stepper motor reset to "turn key on"? Cheers! benny cherokee finaltune yehey.pclr

Hi guys got a link g4 storm,when setting the analog temp to engine coolant, I notice my actual engine temp doesn't match or close to the values on my laptop, sensor was replaced( delphi ECT) chose the calibration and still does the same thing, is there a way to calibrate this? so the values gets close to the actual engine temp. Please find the tune attached Cheers! benny cherokee finaltune yehey.pclr

All good mate i figure it out the distributor was removed and been installed on the opposite side of the clock, causing the revs won't log the second time i tested it, we re- time the distributor and the revs came back, I got both spark and injector pulse,what a mistake thanks for all your help Cheers!

I checked the 12v. power to injectors and igniter/coil all good mate, i use noid light to checked the injector and dwel pulse from Aux ign output

sorry Adam I forgot the tune cherokee tigger.pclr I just want to ask as well everytime I go online it shows a warning about the trigger saying not sure if it will work, I waited for a while for link to release the updated software and Cherokee 2000 trigger pattern is included i don't know why the warning message comes on everytime i go online with the ecu, also the signals seems to be so inconsistent there are tries that theres no rpm signal when get crank and injector pulse sometimes won't work, theres no trigger error showing on the runscreen but still no good, we planned to do wasted spark ignition before but , we decide to go distributor ignition set up hopefully to make it easier , also While testing few times we broke one set of igniter a mitsubishi igniter 3 channel, we tested the signal from aux ignition channel with the use of noid light and run igntion test it shows a good pulse on the noid light, sorry my quiry turn to be a nobel, sorry mate

log st.llg jeep trigger 2.llg

after i update my pclink software i chose cherokee 2000 as trigger pattern, i can see revs on the runtimes values when starting and no trigger errors , but no ignition and injector pulse, do we need to edit the trigger set up? or is there any available settings I can use and try, thanks for your reply cheers mate I use mitsubishi 3 channel igniter with coils from a mitsubishi triton

Good day, Got my Jeep Cherokee with lnkg4 ecu trigger pattern was set to Cherokee 2000, the run time values seems working perfectly but no spark, it is set to wasted at the moment, what could be the best setting to make this going I got message on the screen when cherokee 2000 is chosen on the trigger pattern, scan someone guide me please, thanks heaps

i got the same issue ,i tried to update my firmware few times but still the cherokee 2000 is not included in the list, any tips or do i need to have a newer lap top cheers!