DCSpeed

Streams 7 & 8 i am going to use for the can bus expansion which will have the fuel level senders nitrous pressure some voltage input switches for boost maps strain gauge for sequential and a gear position indicator etc. i did wonder if it was possible to condense all the inputs to the pdm into one stream over afew frames but it does not seem to user friendly unless you are in the know. This is the pdm setup you helped me with last year when i was trying to figure out how to talk from the link to the pdm. Motec PDM Mirage Adam.pdm

This is what i am trying to make work. I think i will end up putting the dash and the can bus expansion module onto their own channel to can channel and keep the pdm, pdm buttons, egt seperate. c125 dash.lcs mirage.pclr

yes i have 4 custom ones for the motec pdm i have on the same bus. i can delete those streams for the pdm and still have a problem with only getting 15 parameters in a stream over 5 frames. the reason i am trying to get everything onto one stream is that i am planning on having a egt sensor over the same can bus and i have a can bus expansion module in the rear of the car. so i am running out of spare streams to use on the ecu. I would be nice if i could save my configuration can then select it on the data mode tab.

Is there any way of getting around the limit of too many parameters in the stream? i want to build a custom stream to send from my g4+ fury to my motec c125. i see that you can load a generic dash on the mode page and it will work fine, but if you load that stream on the 'stream' tab it will come up with the same error saying too many parameters in the stream. i am not trying to send as many parameters as the generic dash. is there a way to save my custom stream and make it a option on the data mode options?