KevR32GTR

Hey Adam, i went ahead and depinned everything but the white and green wires, and got it to connect. i was able to get the aim to transmit, but when i go to can set up and select CAN 1 options as shown in the instructions, i am not getting any data to feed over to my AIM MXS Strada.

Link geniuses, I am attempting to install my link Strada MXS to my G4+ PNP GTR ecu. When i connect the CAN 1 connect to the ECU board, my ECU goes offline, and i lose connection from my PC. if i unplug, it connects right back. I am able to plug into CAN 2, and everything is fine, it still allows me to connect. Have any of you seen this issue? Also, can i run the link dash on CAN 2 (OBD) or does it have to run on CAN 2 (RS232). Thanks, Kevin Quick note i forgot to mention. I am using the CANPCB connection, with the CANDASH flying lead. i read another post on this forum that stated the issue could be that not all 4 wire are connected. Do i need to use the CANF connector instead of the CANDASH?

Thanks Adam! i will try this today and report back. i reinstalled the factory CAS last night and it fired right up after i did ECCS sync. i will put on the PRP trigger and try again with the instructions you mention above. thanks for the help.

Thanks Adam, i tried that and i am still getting the same results. i looked at the gapping for the hall sensors, and they are within the spec that PRP states. i tested power to both cas and crank signals when cranking the engine. CAS stays around 4V, but crank drops to 3/2.5V when cranking.

Hi Adam, attached is my log and calibration file. something i wanted to mention, when i test ignition with a sparklight, i am getting spark during my test. R32 GTR Cranking Log.llg Nissan R32-R34 GTR G4+ Xtreme Plugin - NEW CAL V1.pclr

I set the offset to zero, and reran a trigger scope. Along with not getting RPM, i realized i am not getting spark either. i assume it is because my triggers are not syncing.

Neil, it says I cannot adjust the arming with this not being a reluctor sensor.

Hi Neil, it is 1.5V

I recently installed the PRP trigger kit on my R32 GTR, RB26. I am having issues getting the car to start. A few things to note. It is a built RB26, PNP G4+ ECU, VR38 coil pack. I wired in the Trigger kit as explained on the PRP site, and i get signal on both trigger 1 and trigger 2. I am not getting any trigger error counts. one thing i noticed was i am not getting an RPM reading when i am cranking the engine, and i lose power to the ECU while cranking, if not plugged into a charge box. below is my settings, trigger scope and syncing. One issue (maybe the problem) is i do not have anyone to crank the engine for me so i can check my timing marks and set offset. i was hoping to get it to run so i could sync my timing. thanks in advance for the help. Kevin