Panos MZR
Members-
Posts
26 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Panos MZR's Achievements
-
Hello. I have an S13 at the shop with s15link rev1.4 and coil no.1 won't trigger I gutted the stock igniter to run S15 coils. 2-3-4 work normally. I have continuity from ecu pin 1 to coil no.1 trigger. My jumpers are set per manual for 90-93 model. Everything works fine except coil no.1 Does anybody have any idea? Thanks
-
The issue is that i don't have the ecu. I want to know if it works so I can order it
-
When I installed my zf gearbox I had to read speed via the wheel so I tapped on the stock abs sensor and had abs error codes. I then installed another standalone sensor on rear hub to work properly. This is what am afraid is going to happen with the Link.
-
Hello. My mx5 is eqquiped with stock abs and vr sensors. Can I tap on the atock abs sensors and use traction control from the ecu? If so where should the inputs be implemented? DI7-10 work? Will it affect the stock abs system? Tooth count is 44
-
An idle valve with a fuse. Never seen that one before. But now is resolved thanks Adam fuse box contacts were not good
-
Any other suggestions?
-
Idle valve is connected
-
I checked from the ecu side and there is no voltage after ecu. So issue probably is the ecu
-
0V on both conditions.
-
Confirmed 12v on pin 109. Tested as above still doesn't work
-
Will do and reply soon. Thanks