[Z1 turbo engine swap in the RZR 1000]

Honestly, that I think is the problem, ViPec ECU sees higher temperature reading than actually is.

I can compare to the ECU reading to the my temp gauge, but without riding I can't get to 190 and temp flashing.

Plus need the help with AFR gauge hook up for the logging. I use Innovate MTX L, but analog output from them is set for AFR. In the ViPec manual look like the calibration could be done in the AFR, but in the drop menu for calibration AFR is not as option, just Lambda .

THX milos

This is what manual say :

Example

The air fuel ratio corresponding to 0V is 9.0:1 while the air fuel ratio corresponding to 5V is 19.0:1. This information should be entered in the following way.

· Output Units - Set to AFR as we want to display Air Fuel Ratio

· Input Value A - 0.00 V This is the sensor voltage at the first point.

· Output Value A - 9.00 AFR This is the AFR at 0.00 V

· Input Value B - 5.00 V This is the sensor voltage at the second point.

· Output Value B - 19.00 AFR This is the AFR at 5.00 V

[Z1 turbo engine swap in the RZR 1000]

This screen shot I took is not with the engine running, just stay there after engine was turn off.

milos

[Z1 turbo engine swap in the RZR 1000]

Not sure if is right way, but I set it like that.

[Z1 turbo engine swap in the RZR 1000]

Thanks, but if I run stock ECU the temp warning is not flashing in the speedo on such low temp like does with the Vi Pec. Not sure why would ViPec seeing higher temp than stock ECU...not 100 % sure, but I think temp warning flash should start when temp is close to 210.

thx milos

[Z1 turbo engine swap in the RZR 1000]

Hi, I run Z1 engine in the RZR 1000 using ViPec AC 11 with this swap. But my temperature warning is flashing too soon , around 190. But can't figure out how to rise the warning, if even possible in the ECU programing. Any help will be really appreciated .

THX milos