Subaru GF8GT Speciale
-
Posts
3 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Subaru GF8GT Speciale
-
-
Hello and regards from Germany!
I have a big problem with my Subaru GT MY97 and the Link G4 Plug In ECU.
My Engine is a EJ20T from the 1th Legacy Generation. The heads are ported. The Exhaust is a 4-2-1 EL Header with a 3" catless Downpipe. Turbo is a ported TD04. Injectors are stock on 36psi fuel pressure. 4 space crank trigger + 1 tooth on the camwheel
ECU:
MainCode Firmware Version 4.8.1
BootCode Firmware Version 1.4
Main Board Revision 1.2
ECU Type Link G4 Strom TopBoard
ECU Serial Number 3722
LinkID 8001
Â
All Triggers and sensors works fine . After 3 week cranking and 900€ for a stronger ignition system if found in the rumtime values and in the logger the problem.
The Crank enrichment doesent lean up and the post start enrichment doesent start over 400 RPM.
the normal cranking speed is 180-200 RPM.
See the Log in the attachment
Â
Whats the standard firmware for this ECU and how can i fix the problem. the Engine doesent run with this ecu
-
Hi
Â
I had the same problem in my MY97GT. Have you checked, that the crank trigger is trigger 1 and the cam sensor trigger 2 is?
That was the mainproblem in my car. The 2nd was the Trigger position. The best reason is to control the TDC mark with a timing light. On my Engine the Camwheel trigger is 180° offset
Â
Greats
No Post start
in Engine Tuning
Posted
Hi
Â
Yes! I have change to multitoothwheel with 4 spaces on crank and 1 Pin on camshaft. It works fine and gives a clear RPM Signal.
I´ve found the post start problem. the crank enrichment hold te blockend the post start activation.
The standart wrx V3-4 map is too rich for my engine. I´ve try to lean down the map, but the engine does not start over 584 (max.).
Next try will be to pull the car with a other car for a high rpm start!