melvindass

Hi , Im clueless as to how to set this up properly. My current setup is running Single Zone Inj Timing Mode , Inj Timing Position at the End of Injection and Inj Timing is set to 400deg BTDC. Appreciate if someone can guide me as to how to optimise this feature. Also I notice there is a table option but Im not sure how to use it.  Thanks, Melvin

Hi Simon, Ive managed to get 2 units of Bosch 3 channel Igniter with connectors,pigtails and heatsinks. The P/N is 0 227 100 203. Its a 7 pin Igniter. Appreciate some advice on the wiring diagram to hook this up into my 2JZ-GTE engine loom.  Thanks, Melvin

Thanks Simon, Ill have a go at the dual Bosch ignitor setup.  Regards, Melvin

Hi , Im currently running stock coils(COP) on my 2JZ-GTE with the standard Ignitor. My setup is using the Link G4 plugin which runs the ignition in wasted spark. Currently am unable to run boost above 18psi due to ignition breakup. The coils are new. The limit for dwell time for the stock ignitor is 2ms. Please advice what would be a good setup for an aftermarket dumb ignitor which will be able to handle at least 3ms dwell. I Should I run the Bosch 0 227 100 209 (2 units of 3 channel) or should I just go for a Haltech HPI6. Alternately can I run 2 units of stock 2JZ-GTE ignitor using 3 channels from each ignitor ? The stock ignitor is heating up due to wasted spark mode firing 2 channels at a time.  Appreciate any advice to solve this issue.  Thanks, Melvin

Hi Omer,  Ive sent you an email  Regards, Melvin

Thanks Simon, Will send the unit back. Regards, Melvin

Hi, I noticed that the BAP figure for my Link G4 Plugin MKIV Supra is showing me a reading of 95.7kpa and an altitude reading of 540m. The place where I live is 10m above sea level. The help files says that the BAP sensor is calibrated from factory. Question is how do I get this BAP sensor to read the correct altitude? Appreciate the help. Thanks. Â Heres the ECU info : [1:14:37 PM] MainCode Firmware Version: 4.10.2 BootCode Firmware Version: 1.4 BAP Calibration: 56 MAP Calibration: 1 Support Board Revision: 0 Main Board Revision: 1.2 ECU Type: G4 Storm TopBoard ECU Serial Number: 17247 Authentication Number: 11 LinkID: 8001 ECUMinSpec: 4:101 Â Regards, Melvin

hi simon, do you have any feedback for me ? thanks melvin

Hi, I purchased a Link G4 plugin ECU for a Toyota Supra2JZ-GTE non VVTI single turbo a couple of weeks ago. Checked the ECU board version and it shows it's a Storm board. Im currently running 6 individual coils on my setup and unable to configure direct spark for my setup due to Storm board limited support for 4 coils. I purchased the Link plugin unit based on the website info that it supports the Extreme board functions. Please advice if I am able to send in the unit for a replacement. Regards, Melvin