Jump to content

Sorenjensen

Members
  • Content Count

    23
  • Joined

  • Last visited

Everything posted by Sorenjensen

  1. Sorenjensen

    Map sensor

    Many thank for your help.
  2. Sorenjensen

    Map sensor

    Is a plugin, i have
  3. Sorenjensen

    Map sensor

    Thanks for the help. The pins on the ecu , I was looking for
  4. Sorenjensen

    Map sensor

    Hi. I need an external map sensor on my Nissan skyline, it has a link 4g ECU, some that can tell me where to install the three wires. Regardes Søren
  5. Sorenjensen

    Map sensor

    Ok thanks for the reply regards soren
  6. Sorenjensen

    Map sensor

    Hi. I have a link 4 g ecu in my nissan skyline r34 gtr, but in the ecu is only a 2.5 bar map sensor, with a maximum of 1.5 bar boost, how can i install another map sensoe, to get more boost on. Regards Søren
  7. Okay, Haw many measurements should i do, and howi write it into the pc
  8. Hello again. how do I calibrated my aem air / fuel wideband to link 4g. at my watch shows about 14.7 to 15.2 at idle and on the PC shows the 8.7 idle, I will run quick tune program. because it gets too much fuel, the car is nissan skyline r34 gtr. Regards
  9. Hello I have set your air / fuel watch over my ecu box, red wire pin 49 black wire pin 50 white wire pin 29, and will then run quick tune, but it gets no signal, what have I forgotten to do, or I mounted the white wire wrong. euc is link 4g plug in for nissan skyline r34 gtr. Regards søren denmark.
  10. Hello. ok I will try when coming home from work. Regards søren Â
  11. hello. I adjusted it up and down the table, but when there is boost pressure is the air / fuel goes into the red zone, so that they may find out when they maper its. Regardes Søren
  12. hello. I thank you very much for your help, it has been a great help , I will transfer the gasoline table tomorrow morning, and write how it goes.  Regards søren
  13. Where can I find the main fuel table and adjust the table
  14. Yes   a wideband air fuel meter to check Air Fuel Ratio's, I upload the file and try to start up Again.
  15. yes it can start. but it gets to much gasoline, where can I adjust it. it should read regards søren
  16. yes it can start without giving it too much gas, where can I adjust it. Regards søren
  17. hello. I will try, so'll let you know if it works, but many thanks for your help. Regards
  18. how long do you answer the question, is 11 hours ahead of you, so it's night here hope you can help me, I need the car mapped.  Regardes søren
  19. fuel injectors is Rc racing (rc pl 4-1000)  Regards søren
  20. it is a plug in box, the original is removed, What is it I have to send you the program as I have read into the box. Regards søren
  21. Hallo. I have come to load a program into my ecu that comes with the software I dovnloader to my PC, the program is nissan skyline gts-gtr, and has unfortunately not saved the old setup, so now the car will not start, it gets fuel but no spark at the spark plugs, what can I do other than make a factory setting. The car is a nissan skyline r34 gtr with 1000ml fuel nozzles and stoket to 2.8 Regards søren denmark
×
×
  • Create New...