pault

3 from memory on both 5v and sensor ground

Turned out to be a faulty Cam Sensor, and the buggy drove in on a OEM Denso setup. Never ceases to amaze what can go wrong Bench tested new and faulty sensor to confirm, fitted the replacement, got a good signal on scope and I still could not get it to run, popping and banging etc. Couldn't figure out where I had my firing order wrong until I realised Cyl 1 isnt at the chain end of the engine like it is on a car engines. Everyday is a school day! Up and running sweet now, thanks for youre help.

Hmm I wonder what my issue is then, I have it wired correctly according to that. I must double check my trig 2 from sensor to ecu header in the morning. Thanks for you're help !

Did you power it from 5v also Greg? I suppose you could hardly confirm the sensor pinout for me to double check, I must have it wrong.

Hey As above I have an Xtreme fitted to a K6 or K7 GSXR 600. Im having issues getting a Trig 2 signal and rpm reading. It's a 3 wire sensor with 5v, sensor ground and signal. Setup as optical/hall and cam pulse x1. Ive tried going through all the settings such as filter level, rising/falling, pullup on/off etc. Nothing on the scope. Anyone shed any light if I'm missing something silly? Engine was running fine before hand so suggests cam sensor is good. Turn off Trig 2 and I get a rpm reading so all other settings I presume are correct. Cheers.

Worked a treat Adam, thank you.

Perfect. I will have the car back in tomorrow and will try both. Thanks a mill.

Whoops I was being stupid, still had it set to Generic Dash and never copped it! I'm fitting another today with a Monsoon and I downloaded the stream file at the end of the other thread, everything is good apart from the negative fuel pressure. Could you possibly confirm the latest stream file? Thanks for your help Adam.

Hi Adam. I'm having the same issue on a car here. Came across this thread so i downloaded your latest can stream above. The only thing I'm doing differently is I'm loading the stream into Stream 3 as I have other CAN functions on 1 and 2. When I load it in it pops up a warning box saying too many parameters in stream. I deleted they last few frames with Knock etc as I'm not using them and it then lets me apply and store however pressures are still reading 10% like Simons issue above? Ive downloaded latest software and firmware for both and must have another try as I was a bit out of date. Any ideas? Cheers.