Paddy

Good point, ill see if it works. Thanks again for the tips

Now that i can simulate RPM, Can I simulate the fuel consumption to check that on the dash also? Is it possible to select injector testing etc to simulate a fuel flow? Thanks

Ok, got it working! thank a lot! FYI on these settings 300Hz ended up being 6000 rpm

Awesome! The aux test PWM cant go above 300Hz, to simulate higher rpm, should i change the tooth count on the trigger setup?

Hi, I am installing a Thunder into a 350z and i need to test that a few of the can outputs are working. For most i can simulate these by wiring the sensor to inputs then moving it, or by using a trimpot, but i was wondering if anyone knew a way to simulate the RPM input? Is there a way to force an RPM signal onto the pre-configured 350z CANBUS settings to test the gauge cluster? Any help would be great!