-
Posts
21 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Everything posted by Kimple Fi
-
Because the next time I connect to the ECU, the can settings are zero. I guess the installation didn't work then !?
-
I can't start the engine now because the cylinder head is in the machining center. I'll try again later when I get the machine up and running
-
I have the latest Firmware and software too.
-
-
Hi! Now I have severed wires. Now my computer will stay connected to the ECU :). But i dont stay in ecu can lampda settings!?. I can do them on a computer and send them to the ECU, but when I contact the ECU later, the settings have uninstalled can lampda. What am I doing wrong !?
-
Ok. I have two kinds of instructions. I try another . Thanks
-
With candash cable 5wire. Do i need to power the can lampda outside the ecu?
-
Hello This how i wiring my can lampda . Is that ok !? I think I've made connections correctly in accordance with the instructions. Can lampda was fully functional before I upgraded to ECU.
-
Hello everyone ! We load newest software and put ecu latest firmware. Connection ecu and laptop Works fine. When you assembly can-lambda, then connection lost. Have any same problem?
-
The problem is over. I don't know where the problem was, but now I'm getting in contact to ecu. I checked the programming cable and reinstalled it and now it works. Thanks Adam for the quick response
-
Hello everyone!. I have a problem getting in touch with my ECU. I uploaded new firmware inside the box and now I can get contact the box. What can be done !? Desperate
-
Thanks to you Simon
-
How i wiring ethanol sensor to my plug in g4+ toyota altezza sxe 200 ? Thank you
-
Hi everyone. I am replacing the original injectors (340cc) larger injectors(1600cc) .. What do I need to change the settings?.
-
Ok Thanks to you Adam Kimmo
-
Ok Thanks Simon ! Can I use "vehicle speed input" (DI 3) for example, because this is left unused in my assembly ? Kimmo
-
Hi guys ! Which pin must connect to the Launc Control , Altezza plug in g4+ ? Sorry my English Kimmo
-
Hi Adamw ! Thats help me . Thank you Kimple Fi
-
Hi everyone ! . I have plug in altezza plug in G4+. I should know which wire connected to the "Start signal" pin ? (Digital input). Sorry my sadly English :(. received_10208079831497910.mp4