Guest |99| Posted November 6, 2008 Report Share Posted November 6, 2008 I am planning to run with different boost tables in different gears and have set the selection of Tables 1 - 3 based on activation of AUX OPs 9 and 10. The switch condition for 9&10 is: if gear < 2 then turn AUX 9 on which then activates Boost Table 2. If gear > 4 then activate AUX 10 which then activates boost table 3. If the AUX outputs are not physically connected will this method still work or is there another way to achieve the same thing? Quote Link to comment Share on other sites More sharing options...
rayhall Posted November 6, 2008 Report Share Posted November 6, 2008 To have a different boost in each gear you setup the Y axis of the boost table as gears. See example below. Ray. Quote Link to comment Share on other sites More sharing options...
Guest Marcel B Posted November 13, 2008 Report Share Posted November 13, 2008 To have a different boost in each gear you setup the Y axis of the boost table as gears. See example below. Ray. So I guess that this would mean that one boost table is all that is needed :?: Quote Link to comment Share on other sites More sharing options...
rayhall Posted November 13, 2008 Report Share Posted November 13, 2008 So I guess that this would mean that one boost table is all that is needed ? Yes, one table is all you need. Quote Link to comment Share on other sites More sharing options...
Guest Marcel B Posted November 15, 2008 Report Share Posted November 15, 2008 So whats are the other two tables used for ?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.