Davidv Posted March 2, 2015 Report Share Posted March 2, 2015 Hey, I've wired in a 3 axis accellerometer to Analogue inputs 9, 10, 11. Used a Cal table with no units, as there is no 'G' unit available. But if I try approximate the voltages to Gs, because it only goes from 0 to 3, with two decimal points it doesnt have enough resolution to be effective. If I set my units at each end of calibration to be '0' and '6000' then I get lots of resolution but the numbers dont make any sense at first glance. Ideally I'd want to have my scale going from -3 to 3, with a lot more decimal places. Doable? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.