Andrew Theurer Posted August 27, 2007 Report Share Posted August 27, 2007 Anyone controlled the vvti on the 1/2/3UZ Toyota motors with a G3 yet? I saw on the software that the crank/cam trigger timing was already available, but I did not see a similar option for the cam control. Thanks... Quote Link to comment Share on other sites More sharing options...
ashesman Posted August 28, 2007 Report Share Posted August 28, 2007 One of our engine dyno's runs VVT on a 2UZFE. As far as I know nobody else has used one of those motors for anything yet! I have a dyno sheet here showing the difference with VVT control, on and off and inlet runner control on and off... Anyways there is definitely working VVT control for a 2UZFE... Quote Link to comment Share on other sites More sharing options...
Andrew Theurer Posted September 1, 2007 Author Report Share Posted September 1, 2007 That's great to hear Ashley. I would love to see those dyno sheets if you have them available. It sounds like this is the ECU for me. Quote Link to comment Share on other sites More sharing options...
ashesman Posted September 3, 2007 Report Share Posted September 3, 2007 Check here: http://www.linkecu.com/products/engine-management/Plug-In/1uzfe-dyno-shot/view?searchterm=1uz Quote Link to comment Share on other sites More sharing options...
Scott Burns Posted January 23, 2008 Report Share Posted January 23, 2008 you say its a 2uz on the dyno sheet its says 1uz do u haave a dyno witch shows you what kinda power it makes with jsut the vvt on and off with the inlet runners off Quote Link to comment Share on other sites More sharing options...
ashesman Posted January 23, 2008 Report Share Posted January 23, 2008 No... why would you run the motor with either VVT or runners not working... Quote Link to comment Share on other sites More sharing options...
mark smith1436215439 Posted February 3, 2008 Report Share Posted February 3, 2008 hi people, i am curently in the process of bulding a twin turbo 1uzfe vvti and am wanting 2 know az much az i can about how well it has worked 4 other people that have used a g3 plus on a vvti 1uz and mor importantly at the moment some one 2 wire it up....... Quote Link to comment Share on other sites More sharing options...
ashesman Posted February 3, 2008 Report Share Posted February 3, 2008 We have sold quite a few systems for VVTi V8's, but I haven't heard a lot of talk on these forums about it. Have a look on the dealers site of our web page to find someone close to you for wiring. Make sure to test your intake running solenoid, and vacuum system as the solenoids fail and vacuum systems leak... Quote Link to comment Share on other sites More sharing options...
danny cheung Posted October 24, 2011 Report Share Posted October 24, 2011 Hey, i'm after a tune map to suit the toyota 3UZ-FE v8 that I can load onto my G4 xtreme to run the engine nicely in standard form.because we dont have dyno 3000 miles range, so extremely grateful if anyhelp I can get. cheers ! Email [email protected] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.