Guest |189| Posted March 11, 2009 Report Share Posted March 11, 2009 Ray on the subaru ver6 v44 are you able to run an added boost table on an analog input, I'm wanting to run anti-lag, launch-control and an additional boostmap but there are not enough digital inputs, once car is in full race trim I will gain once as A/C will be removed but until then is there anything that can be done, should have looked into inputs more prior to purchase other wise i prob would have gone with v88.. Josh Quote Link to comment Share on other sites More sharing options...
rayhall Posted March 11, 2009 Report Share Posted March 11, 2009 There are 2 x Volt inputs available on the expansion connector. You can use a Volt input connected to a switch to for boost pressure increase. Set the Y axis of the boost table to Volt, and setup the table values so the boost changes based on 0 to 5 volts. The volt input will need a pull up resistor. The easiest way to achieve this is connect one of the temp inputs on the expansion connector to the volt input. All temp input have a pull up resistor. Ray. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.