[MR2 NO SPARK From 1zz COIL ON PLUG!!]

sooo i tried to wire it and still no luck. Ran a spark test and nothing. so im going to try tommmrow again see if maybe im missing somthing 

[MR2 NO SPARK From 1zz COIL ON PLUG!!]

 Shweet I'll try first thing in the morning and give you guys feed back this forum is awesome forsure. Appreciate it guys

[MR2 NO SPARK From 1zz COIL ON PLUG!!]

Only thing is my expansion harness is ign 5,6,7,8 were my coils are hooked up on as in the pic. Do I still use 1,2,3,4 or keep it at 5,6,7,8. 

And wiring is set up correctly check with volt meter again just now. I'm going to check the spark edge tommorow since had to go to work lol. 

[MR2 NO SPARK From 1zz COIL ON PLUG!!]

I've taken cyc 2,3,4 off. Changed main spark to direct spark  And turned igntion 5,6,7,8 on. Since I have a expansion harness for it

The ignition test still no spark. Turned it on one by one still nothing. I'm geting power 12v and the trigger gets 8dc volt at standby but when I crank goes down to 4dc volts. 

Ive change dwell even to  different setting from 2 or 3 different points what I've gotten online and still nothing yet

 

[MR2 NO SPARK From 1zz COIL ON PLUG!!]

hey everyone i built a 5sgte motor thats on gen3 head and electronics. This is the first start up but i change my distributor to  1zz coil on plug and pnp harness. It is geting power to coils and the trigger 1 and 2 both say yes when cranking. but still no spark. i set dwell to these setting from a friend who sent me a base map anyone have any ideas?