darts99
-
Posts
14 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by darts99
-
-
still having issues no map sensor will calibrate
-
ive tried 6 different map sensors and its still not calibrating, the lowest is 80kpa.. all wiring for the map sensor has been checked and tested. The latest map sensor thats in the car is a gm 3 bar, is reading (90 map) so wont calibrate with the 101 baro.
-
yes ive changed it back to map. i did a compression test today and engine is healthy.
map sensor is built into the throttle body with a new gasket
-
car seems to be getting flooded after a couple cranks, any reason for this?
-
okay and yes v9 map sensor injectors are sti pink 550s. the car ran 14.7 at idle before it stopped running.
okay so i did absolutely nothing and it sorta started on first crank when i was doing the log
-
yes its stable
-
hey just seeing if anyone has any input as to why my car wont start. I got the link ecu installed and set up, got the car started and idling (was very shaky) car started right up every time no issue for about a week.. all of a sudden the car would not start no matter what i tried. I had stalled the car a few times so i thought maybe it skipped a tooth, sadly thats not the case. i tried the injector test and ignition test both were a success. even tried new map sensor,crank,cam sensor still wont start. if anyone has any ideas please let me know. thanks!
-
that worked ! thank you so much!
-
its grounded on the same ground as the ecu uses ( engine block). ive tried switching it to voltage 0-5 and got no fluctuation in voltage
-
hi again, im having issues with my 1 day old wideband. wideband is getting switched 12v and is being grounded on the ecu ground. white wire is sending signal to my stock o2 signal wire. The signal in pc link is not moving(10.0 afr) where as the wideband gauge its self is leaning out. ive been having a hard time getting the car to run and i believe this is why.v4 type r map.pclr
-
-
still sending the same error code when i try to calibrate the map.
-
Hi, im brand new to tuning and just setting up my first ecu! my current issue is getting my aem 3.5 bar map sensor to calibrate. I have a friend with the same exact set up as me (98 sti plug and play link g4+ and 3.5 map sensor) so ive copied his map sensor settings and i get error current
map <5kpa or >5kpa of baro reading. any ideas?
car wont start. v4 type r sti
in G4+
Posted
The only way i can get one sensor to calibrate is to set up password protection, then baro calibration shows up, so i calibrate it at 101 kpa and then 1 map sensor will calibrate but its not working properly