Flat4supersport
-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Downloads
Posts posted by Flat4supersport
-
-
Is this possible? I was hoping to have both read lambda values but since activating the CAN Lambda the Lambda 1 parameter is now reading the CAN Lambda not internal Lambda.
-
Thanks for the Reply Adam, I’ll continue with getting it sent out to them, cheers.
-
Hi Guys,
Went racing yesterday and my internal Lambda was dropping out, I was getting Error 52 "Can't read diagnostics", had a bit of a conversation on Link Live chat and supplied a photo of the ECU board to representative (maybe to check revision info?) and it looks like I may have to send the ECU to New Zealand to get checked/repaired which is a bit of a pain, anyway I wanted to re-trace my steps from last season when I put the car away with no issues as had changed ignition coils from Audi R8 to Nissan R35, did a continuity test on all 6 Lambda wires and all good from connector to ECU.
Because ive known of other cars with "issues" today I fitted a set of "Resistor" spark plugs (had used non resistor plugs with no problems prior to changing the ignition coils) and the error 52 has now gone, but now if i rev the engine to 6000 RPM approx Error 6 appears,(6 - Internal control error, no user actions can be taken to correct. Report this to your Link distributor.)
The Lambda no longer drops out and appears to be working fine, maybe I still need to send it for repair/fix, wondered if anyone else had had this code?
-
Thanks JMP :-)
-
Does anyone know where the cranking ignition advance value comes from?, is it the main ignition map just at the low RPM sites?
-
Yep, that was it Simon, thank you
-
Hi Adam,
Actually I have tried that as well as all of the other dropdown ones, i'm showing a low voltage input fault but have checked wiring continuity back to the ECU on both the ground and signal pins and all good, I suppose the sensor could be duff but it was ok before I changed the ECU from AEM to the Fury, I will investigate further tonight, thanks.
-
There is no drop down Cal Data for this sensor, anyone have any values for a cal table please? Engine is early V1-3 type.
thanks in advance
chris.
Using Fury G4+ internal Lambda alongside CAN Lambda
in G4+
Posted
Awesome, thanks Adam. :-)