madeonLiu
-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by madeonLiu
-
-
hi adamw,
thanks for your replay as soon as possible.
so is not possible to trigger fan from can digital input ? only the physical aux for fan pin and virtual aux is configurable ?
thank you.
sincerely.
-
-
Hi all,
above the topic i know the CAN can be digital input setting.
the CAN digital input 1~8 is mapping to physical Digital input 1~8?
or its possible to setup the CAN digital input independent the physical digital input ?
how could I edit it? cuz I only can see the can dig# status in parameters page does not show at ecu setting page with a independent table .
thank you
-
hi adamw,
thanks for your passion reply as soon as possible especially at holiday.
that really help for me
after instruction from your method,
everything is work perfectly
thank you
sincerely
-
by the way ,
after show the log,
I already turn off ignition and disconnect the battery off
then connect again then pclink then connect to link by com successfully.
then update the firmware with same version again , still not work ,
please the suggestion ,
thank you
sincerely
-
ECU is running in........BOOT MODE
Warning: Last update was not complete. Engine will not start in this mode. Continue with update to boot main code.
Current ECU firmware information
-----------------------
ECU firmware version : 5.6.8.0
Bootcode Version : 1.9
Board S/N : 51241
ECU type : 25Read the version notes before proceeding
Have you read the firmware version notes?
New firmware information
-----------------------
Firmware update version : 5.6.8
Creation date "6/11/2020 10:41:26 AM"Reinstalling from : V5.6.8 to V5.6.8
Warning : Programming will overwrite your existing firmware
though tuning information will be retained.You may be required to configure any new features after
this upgrade to ensure continued ECU operation.Under no circumstances should this process be interrupted.
Please leave ignition switch ON until update is complete.
This should take approximately 33 seconds.Do you want to continue with update?
Backing up basemap failed. please check release notes for changed settings
PROGRAMMING HAS STARTED......please wait approx. 33 secsPLEASE CYCLE POWER TO ECU i.e. switch ignition off and on
and then click OKWarning: ECU expected to be in bootmode but an unknown code was detected.
Will skip the booting of main code stage
It might be advisable to cycle power and re-do update again
Error Code: 1019does have any suggestion to do the standard process ?
thank you
sincerely
CAN information
in G4+
Posted
hi talent,
its fantastic !
i got the can di for condiciton
thank you