[Reluctor and 24 minus 1 cam trigger]

Solved it finally! Whilst checking those pins i noticed a fault with my own wiring. Thanks for the help mate i wouldn't have noticed it if you hadn't told me to check those pins lol.

[Reluctor and 24 minus 1 cam trigger]

just tried that, still no luck unfortunately 

[Reluctor and 24 minus 1 cam trigger]

Would that problem still be an issue if in my case i have rewired the sensor completely? i ran new shielded cable from pins 42 and 52 directly to the sensor and then connected the negative wire and shielded braid to power ground  / pin 60. maybe i was not supposed to connect the shield to that pin or something??

[Reluctor and 24 minus 1 cam trigger]

Tried changing the trigger mode back and forth like you said, then changed arming thresholds to your example. still no luck, heres the log file

Log 2.llg

[Reluctor and 24 minus 1 cam trigger]

Screenshot of the parameters during cranking also

R32 GTR 1.pclr Log 1.llg

[Reluctor and 24 minus 1 cam trigger]

I will upload a log and tune file tomorrow. I dont think i saw a yes next to the trig 1 signal now that you mention it. I'lll that check tomorrow and im also pretty sure the trigger error counter wasn't counting up. Thanks for your time trying to help me out so far mate.

[Reluctor and 24 minus 1 cam trigger]

Unfortunately still no rpm, not even a hint. I have tried different sensor spacings but still no luck. This is my first time setting up a non-oem trigger so ive run out of ideas

[Reluctor and 24 minus 1 cam trigger]

Heres a better resolution scope, i mesured the gap with a ruler on screen and it seems to be pretty much exactly the same width as 2 teeth spacing

[Reluctor and 24 minus 1 cam trigger]

Yes its basically an exact copy of the nzwiring kit, same wheel and sensor

[Reluctor and 24 minus 1 cam trigger]

Hmm.. okay ah heres a scope of it with an air gap i had previously (about 0.3mm more gap) and yes polarity is wrong haha

[Reluctor and 24 minus 1 cam trigger]

Ive been having some trouble with a bosch vr sensor and a 24 -1 trigger disc on the cam wheel of an RB26.

Setup is similar to the nzwiring kit. Does the trigger scope picture look correct? (correct distance between sensor and trigger disc)

It simply wont register any rpm value

TIA