Tabz
-
Posts
11 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Tabz
-
-
Yes that is correct, sorry wasn’t clear enough
-
hi-i saw a link but its broken, can anyone could point towards setting up idle control without a stepper motor in evo 1 , thanks
-
Cool thanks Adam
-
Hi if any wiring diagram available for the above, dealing with messed up engine harness , thanks in advance.
-
On 7/6/2021 at 9:16 AM, Adamw said:
It certainly does appear to be protected. I cant open it either. To protect a map you need to type in a matching password twice to lock it so its difficult to imagine it was done by mistake.
what do you think of the software versions? Would this be an issue? only thing i did was wire up a boost solenoid
-
Bit strange was not locked few months back , the only ecu related work I did was hooking up a boost solenoid where I disconnected the ecu.
-
-
Hi there, when I got the car from the tuner sometime last year I had hooked up my laptop and it wasn’t password protected but now when I connect it says it’s locked , tuner did not put a password. The current version firmware is 5.6.4.3240 , how can I get rid of this protection?
-
thank you sir much appreciated:)
-
hi , i would like to wire up a boost solenoid with a switch to run high and low boost(gate pressure), was wondering what aux have people used and any wiring diagram would be helpful.
LF Wheel speed parameter not working
in G4+
Posted
hi, my evo 1 wheel speed parameter stopped working after the car was tuned, i m guessing the speed is calculated from ASB through CAN, i have tried the ASB sensors from a working car without any success. i believe the CAN setting may have been changed during the Lambda sensor and gauge install. If anyone could check the CAN setting would be appreciated.
attached tune
DR4G final tune on 100oct.pclr