[Configuring CAN BUS setting for g4+ to Racepak iq3]

1 hour ago, Adamw said:

Your ecu setup looks fine.  You will have to check the dash config.

Very very thank you Adamw, i will download the iq3 software tommorow and try to adjust it... 

 

 

 

[Configuring CAN BUS setting for g4+ to Racepak iq3]

8 minutes ago, Adamw said:

Yes the top round port with the red oring on it is the USB port, the lower one is CAN1.  

CAN 2 is on the B plug.

Thanks, its get blinking and everything, but not any values.. i havent download any software to the iq3 but it had go with the link before i got it, its it nessesary to get newcthen?

 

the picture its im my car

My can setup

 

[Configuring CAN BUS setting for g4+ to Racepak iq3]

13 minutes ago, Adamw said:

No, it needs to be connected to one of the CAN ports.  What ECU do you have?  

CAN setup from the help file is below.  Note it says 230-VM-EFILINK, but the EFIUCAN  set up is the same.

Thanks! I have the G4+ extreme, And what im see its i have 2can setup. i have the 230-VM-EFILINKC.  But i have to round contactor in the ecu, ond for the PC and one for the canbus?

[Configuring CAN BUS setting for g4+ to Racepak iq3]

17 hours ago, Adamw said:

As above, for the old racepak you will need the 230-VM-EFIUCAN VNet module to connect to the ecu.  

I have it, Its the iq3 connectet in the same as the PC cable? And what should i type in the can1 setups?

 

[Configuring CAN BUS setting for g4+ to Racepak iq3]

Im bumping this, im also have the dutch8 connector, does i have to download the software with pc and then connect to the G4+ with can1 and its pnp?