[Expansion loom / changing input]

Currently in the process of wiring up my sensors on my Evo 6 with g4x 1.5pcb

 

Will be wiring

Oil temp/pressure

Coolant temp/pressure

Can I change the analogue input on expansion loom to ntc temp in the software?

My options are as I need 2x An temp

1. Changing analogue input to ntc temp if possible

2. Repin An temp 3 and 4 on ecu

3. Wire all sensor into my Link aims dash.

 

If I wire all sensor into the Link aims dash. Will the sensor still work with ecu if I wanted to set them up for a failsafe/protection etc.

 

 

[Multiple Can Connections]

No worries, thanks for clearing that up 

[Multiple Can Connections]

Hey Guys

Currently in the process of collecting parts to wire into my g4x plug in ecu

Will be connecting

Link 5" mxs dash

Link can lambada

Link keypad

 

Just wanted to make sure im going about it correctly

 

The Plan

Wideband =Can 2m extension, canjst into ecu can slot 1. 

Dash = dtm 4 for can high/low, can splitter, canjst into can slot 2

Keypad = Can splitter, canjst into can slot 2.

May require can 2m extension for the dash/keypad.

 

Wire both canjst into seperate 12v switch with a fuse tap and 5amp fuse, no added relays.

 

Any info appreciated

Cheers

 

[G4X Canbus splitter]

Hey there

Have purchased the following

Link 5" race dash

Link 8 button canbus keypad

Link canbus wideband

 

Noticed the ecu only has 2x canbus slots. Am I able to run a canbus splitter to connect all 3 or do I have to get rid of one.

 

Thanks

 

David

[Haltech 8 button keypad on link g4x]

Hey there

Currently looking into 8 button keypay

Thinking 

Haltech keypad and link keypad

Is the haltech keypad plug n play if used on link g4x. 

I can get the haltech keypad on a better deal atm and it comes with all the extra stickers for free.

Will be using canbus wideband and canbus keypad on the other in the canbus board section.

Any info appreciated 

 

Thanks

 

David 

 

 

 

[Connecting Sensor to Evo Maf]

Sorry for the late reply, thankyou for you help clarifying the connections AdamW. Just to confirm if so move pin 85 to pin 44 of expansion loom if I wanted to use AFM Baro Pin as my Flex Signal. 

[Connecting Sensor to Evo Maf]

Hi there

Looking to connect Bosch IAT, Bosch pressure and Flex sensor to the standard MAF connector on my EVO 6.

Bosh Air temp = Signal neg , Signal Pos

Bosch Pressure = Signal neg, Signal pos 5v  ,Signal output

Flex = Signal Neg, Signal Pos 12v, Signal out

 

Looking at the Maf diagram link has supplied

Bosch Air temp = pin 5 and pin 6 ambient temp?

Bosch Pressure = Pin 1 for 5v, pin 5 for ground and either pin 2/3 for signal output?

Flex =Pin 5 for ground , pin 4 for 12v and either pin 2/3 for signal output?

 

Will this work or am I reading everything wrong? Wanted to connect to maf to free up some room on my XS loom for other sensors.

 

Thanks