[Best way to display fuel level on MXG 1.2 Strata]

Thank you Adam, I'll give the Aim hardware a go.

[Best way to display fuel level on MXG 1.2 Strata]

We have a 90 ohm fuel gauge in our Radium cell.
Would like to display fuel level on the Strata.
Bringing the level signal into the ECU is pretty straight forward but not
seeing a screen display setting available in the many different Strata screens.
Doesn't have to be meter style. A percent will do.
Is there a customization for Strata screens I'm not seeing?

[MXG 1.2 Strada displays incorrect value]

Thank you Adam,

Yes, both pressures show correctly in the Link Software.

The dash config was not showing that version, so I updated it and transmitted and now we three digits for Fuel Pressure in kPa.

[MXG 1.2 Strada displays incorrect value]

G4X connected to Aim MXG 1.2 Strada and data connects fine. All display values are good Except Fuel Pressure.
The value is set for kPa (as is oil pressure) but the Fuel Pressure will only display two digits so even thought we know the pressure is 276 kPa (40psi), the display only shows 27 (two digits). The display settings are the same for both fuel and oil. Oil displays three digits (in kPa).

The ECU sensor settings are the same for oil pressure and fuel pressure. The only difference is that the oil pressure has a calibration table and the fuel pressure does not.

I'm starting to think that I need a different fuel pressure sensor?

[Accumsump control from ECU oil pressure]

21 hours ago, wastegate said:

Would something simple like this work? Aux 12 being connected to the relay for the solenoid.

That looks like what I was going to try. Probably use a relay (draws 150ma) as the Accusump solenoid would probably draw over 1 amp. 
THANKS!

[Accumsump control from ECU oil pressure]

350z LS3 n/a swap and Link G4x.
Using Accusump with 25psi pressure switch (switch psi below hot engine oil of 35psi).

Can I setup something in the G4x so that the Accusump activates the solenoid based on oil psi and engine rpm?
For example, I don't want the pressure to get to 25psi above say 4,000 rpm before the Accumsump activates.
I would like it activate if it drops below 40psi above 4,000 RPM.

I did find this: 

 But we have a switch to pre-oil and that works well now.

Thanks!