Phill A
-
Posts
10 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Phill A
-
-
Yes, still live with fuel relay removed.
Aux 1= Idle Speed control, 2 wire pwm
Aux 2= Cooling fans
Aux 3= Rev counter, factory in dash 84 KP60
Aux 4= Fuel pump relay
Aux 5= Check engine light, wired to exhaust temp light in factory dash
Aux 6= Boost control, MAC pwm
-
Hey team,
discovered my monsoon isn’t turning off when I power the key off.
Found my ign relay is getting a low voltage feed back from the +14v ecu wire which is enough to keep the windings energised and contacts engaged.
Ive disconnected everything but the ect and injectors to see if there’s anything external feeding back into the ecu but no change.
Does it require a diode protected relay of have I got something else funky going on?
scribble if my wiring attached
-
That’s it!
just started!!!!
Not running so well and won’t idle, but it go’s.
thanks heaps guys
-
Thanks guys,
Got a spark to cyl 1 and managed to set timing to 10 degrees.Cranked it and got a large backfire so I pulled the offset back to 349deg.
Got spark on 1 & 2 but none on 3 & 4, test function fires all the coils no problem.
Current trigger scope attached,
-
Changed the arming thresholds as per example, still no go.
trigger offset is locked?
-
File attached below thanks
-
Ok, thanks.
I’ll attach the file on Monday when I’m at work
-
No tune done yet, fresh out of the box Link
-
Hi guys,
I have a Link Monsoon g4x I'm trying to get to run a 4A in a KP60.
Have a couple of issues I'm looking for some advice on,
Was working on setup and got to the set the ignition timing part & found it doesn't spark on cranking, fires all the coils in test mode.
I'm using the Link loom and the trigger wiring is set up as per the data supplied on the Link wiring info.
Using trigerscope, 9 times out of 10 there is no trigger 2 pattern.
Is there something in the trigger setup I've missed?
Monsoon not powering off
in G4x
Posted
Thank you,
I’ll change that over tomorrow