[TTLink INPUTS AND OUPUTS LOCKED]

Thank you so much, knew I'd be doing something wrong XD

[TTLink INPUTS AND OUPUTS LOCKED]

TRYING TO ADD AN OUTPUT FOR INJECTOR 6 FOR A CAM CONTROL SWITCHED AS THE ENGINE IM USING ON THIS APPLICATION HAS IT (GETTING BASE MAP SET UP BEFORE BUYING ECU) AND CANT GET IT TO WORK. ANY IDEAS? IF NOT I WILL JUST USE AN ENGINE WITHOUT THIS FUNCTION.

[FORD FOCUS DURATEC ALTERNATOR CONTROL]

Thank you so much, I believe this is the pinout for it, it would be great if thats all i have to do make my life so much easier

[FORD FOCUS DURATEC ALTERNATOR CONTROL]

Component/circuit description	ECM pin	Signal	Condition	Typical value	Oscilloscope setting	Wave form
Alternator	m7		Ignition OFF	11-14V
Alternator	m7		Ignition ON		2 V/2 ms	IMAGE 1
Alternator	m7		Engine idling		2 V/5 ms	IMAGE 2
Alternator	m33		Ignition ON	0-1V
Alternator	m33		Engine idling		2 V/5 ms	IMAGE 3

 

DOES ANYONE KNOW HOW TO CONTROL A ALTERNATOR LIKE THIS USING THE G4+ THUNDER ECU?

 

[Toyota 2SZ-FE (2NZ-FE) HELP]

I have a wiring Diagram for the engine and need help with mapping it into the link software, Going to be using a Fury for the ECU, any help is appreciated.

 

[Toyota 1NZ/2NZ Wiring to links ecu monsoon]

On 8/25/2020 at 9:33 AM, fabiangt79 said:

Hi,

 

Can anyone provide the wiring information for this engine?

I am trying to wire in as a piggyback to the factory ECU.

 

TRIGGER 1 taps in to crank sensor signal

TRIGGER 2 taps to??

 

Also does anyone have the ecu pinout for 2007 toyota vios NCP93?

 

Fabian

Which engine code do you need the pinout for exactly? I might not be able to get you a pinout but i should be able to get you a wiring diagram

[K20Z4 base map help]

On 10/10/2022 at 9:20 PM, Adamw said:

This is not an engine Im intimately familiar with, but likely the "Monsoon Honda K20 Modelled Fuel CLL" map in the PC Link Basemaps folder will have a lot of the basics needed.  

Connect exhaust cam sensor to trig 2 and intake cam to a DI. 

Thank you so much for you reply im sure when the time comes this will get me going so i can get it on the dyno. Im new to all this stuff myself and am wanting to get into tuning so i thought this would be a great first start.

[K20Z4 base map help]

Using a K20Z4 engine on a Link G4X Fury and need help with base map settings. Going to be to be using E-throttle but i can configure that later. Just need help getting all the config sorted.