[G3 running G4 firmware - CANBUS settings (offset, scale)]

13 hours ago, Confused said:

I would consider looking at getting the ECU to send out the Generic Dash stream - all the frames, values and offsets for this are in the Help file.

This might help give you some ideas on scaling and offsets too. Remember that values it will be in metric, so kPa, not PSI, Celsius not Farenheit.

Thanks for the reply. The reason I limited the output is so i can try and figure out what is what from a smaller amount of data. Am i correct in assuming that each of the ID's will be an individual value? so for example ID 064 is showing the ignition angle data.

2 hours ago, Vaughan said:

Downloading and installing G4+ PCLink and looking at the test calculator in the CAN Setup window should give you a good starting point. You can also figure it out if you have some known values in the ECU and matched values from the CAN message.

THanks, I have looked in the g4x software but its offering setupvalues. I'm trying to understand the values using this online calculator

[G3 running G4 firmware - CANBUS settings (offset, scale)]

Hey,

I'm working on an Arduino project to display ECU values from the CANBUS to a display. I have captured some data and now trying to convert that to the correct values but i am unable to find any info on the scale and offsets. The settings window i have is not the same as others, i'm guessing due to age, so i cannot configure the parameters myself.

I'll attach images of the PCLink screen i have and the CANBUS