iron_and_torq
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by iron_and_torq
-
-
5 minutes ago, Adamw said:
You wont need that 10sq050 diode. change the 100ohm pull-up to something like 3-500ohm will do.
Ok, I will try that!
Will I stick with the 10Kohm resistor still? Assuming to dampen fuel slosh?
-
Good evening!
I have been running a Link G4+ PNP on my e36 and have just installed a Powertune Digital Dash. I am now enduring the task of being able to monitor fuel level over CAN. I have done some research and understand most of what I am reading. However, my concern lies with having dual sending units. The resistance ranges from 50-500ohm combined.
I found this diagram (attached). My question is, will I have to use different size resistors since my resistance for the sending units is higher?
E36 Fuel Level Monitoring
in G4+
Posted
Perfect.
I just realized I am using all of my AN Volt pins. I do have an AN Temp left though. Would this be something I could use?