[Jzx100 pnp G4+ first time startup questions]

It’s been a while since I downloaded the base map but I swear it was off this forum somewhere.  I will use the one you supplied and re configure the direct spark and etc with this and I’m sure that was the issue , just the wrong base map

 

the ECT sensor shows Pull up resistor ON here not sure what happened

 

appreciated! I will update when up and running 

[Jzx100 pnp G4+ first time startup questions]

I did get it to run more smoothly by upping fuel master value however. Might be good enough to drive it the 6 miles to the tuner lol 

[Jzx100 pnp G4+ first time startup questions]

 

edited first post to include log files.

[Jzx100 pnp G4+ first time startup questions]

Ok will get those files uploaded in a minute.  
 

Yes I did test ignition 1-6 and confirm all are working 

I did the initial base timing calibration and got my physical timing to match the 10* BTDC on the link but still ran like timing was very off  

[Jzx100 pnp G4+ first time startup questions]

Hello all, this is my first standalone install ever so please assume I am a moron with your replies haha

here is my setup:

stock jzx100 1jzgte vvti with JZX link G4+ using provided base map

stock turbo

stock injectors 

Direct spark conversion (1zz coils), wired using exp. Harness 

aftermarket FPR set at 43psi

sensors installed: IAT, Ethanol sensor, Can Lamba Sensor, Can Gauge

Here’s the issue I’m having so far- trying to set up the timing offset, I can get it to line up at -10 on the crank and the car will start but run very badly and die like timing is very far off. can’t keep car running for more than 10 seconds before it dies to adjust timing … 
 

Also wondering if fuel is another issue due to the aftermarket FPR. No leaks detected but car dies like it’s out of fuel.  Regulator shows 43psi while running though…
 

I am not too well versed in reading the logs and etc just trying to get the car driving so I get it to the tuner 

 

 

thanks  in advance, and I’ll upload any logs/files as needed just let me know what I need to do

 

-Cheers,

John

 

 

 

Trigger Scope Log 2024-03-24 6;03;59 pm.llg ECU Log 2024-03-24 5;45;05 pm.llg jzx100plugin basemap.pclr