Janko_D
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Janko_D
-
-
Hallo, I'm tuning a 2004 RX-8 6 port and can't set up a stable idle. The car drives ok (not tuned completely). This is my first tune, so if you see something wrong on the file, please tell me. The Ecu is G4+ Storm.
-
Thank you, Dave
-
Please find attached a screen shot of the correct setup.
PLEASE NOTE ::::: THE PULLUP RESISTOR MUST BE SET TO OFF or KNOCK CONTROL WILL BE FORCED OFF.
Regards
Dave.
Hi Dave,
Which pullup resistor, the one on DI3? I can't see the screen shot, would you sent it at [email protected]
Regards,
Janko
-
DI3 function is off. Knock mode is ON Knk Internal. I want to wire the knock sensor direct to DI3, Is my Storm Ecu with internal built in knock control hardware?
-
Hallo, I can't set up my knock control. Does my G4+ Storm Ecu (Serial 23058) have a knock control on DI3? On DI5 I have Ethanol sensor and I can't turn it off.
-
I am from Bulgaria. All solenoids are working fine. For the APV Motor (DC Motor) I will use H-Bridge Driver to control it properly.
Thanks for the reply.
Best regards,
Janko
-
Hallo, I'm installing a Storm Ecu on 2004 6-port RX-8 but I have problem with the motor that opens the auxiliary ports - how to wire it in and how to set up the auxillary outputs.
If you have any base map for renesis engine to help me to start, that would be superb.
Best regards,
Janko
Rx8 Bouncing Idle
in G4+
Posted
Thanks for the help, guys