[identify lem v5e]

Thanks for the response.

That is. I need 2 teeth on the crankshaft whom I would like a 4 cylinder motor drive with high-voltage distribution.?

Is that correct?

[LEM V5 trigger]

thanks dave

I'm happy I found help. see what you find out about my lem.

regarding the temp sensors  you have one wire of the sensor connected to the temp pin on the ecu ? YES and the other to Ground?   YES          is anything else connected to this wiring   I.E factory ecu still connected?

no the factory ecu is off the  wiring and car. only the pin´s i have wiring.

I have everything connected to an original wiring diagram from ford and the lem V5e book.

 

[LEM V5 trigger]

hi dave

yes I have a side of the sensor to the ecu and the other side to ground

sensors of the tps and the temp at the factory have the same ground

  hir is the cable or not so good if both are linked

[LEM V5 trigger]

I have found out the men's tooth is an 36-1 rad at the crankshaft but the full 90 degrees before TDC cyl 1,

I must think to install a new gear on the belt pulley with the right time

[identify lem v5e]

Have a nice good day.

I have an lem v5e outside is a label what is a number

Reluctor

D42V5e

070406

and in on the sup-bord

2005/07 s / n 010 743

stand what is and what these numbers

Friware version D42V5e 12Aug05

thanks

[LEM V5 trigger]

Have a nice good day.

I have an lem v5e outside is a label what is a number

Reluctor

D42V5e

070406

and in on the sup-bord

2005/07 s / n 010 743

stand what is and what these numbers

thanks

[LEM V5 trigger]

hello thank you for the quick response

1.the reluctor is to trigger a

I have connected everything in the book as instalations

igniter is to ign1

2.so the ecu has a stick is what (reluctor, D42V5e, 070 406)

 

[LEM V5 trigger]

Good day. I have a LEM V5e Friware version D42V5e 12Aug05 in a Ford Sierra 2.0 DOHC. It's all properly connected the cable. Now my proplem: 1. e temp is in the red area as well as a temp it sint two NTC sensors 2.When I try to start, then the speed indicator trembles on the pc between 2000-4000 rpm It is a distributor, with magnetic sensor on the crankshaft port with 2, was to have trigger 1 and 2 ground all shielded with extra, what can it be? An engine code ford sierra dohc N9A 92kW motor Year 1992 I hope you can help me love you for your effort (sorry for my Englich.'m German)