Jump to content

Matt Jenkins

Members
 View Profile  See their activity

  • Posts

    13

  • Joined

  • Last visited

 Content Type 

Posts posted by Matt Jenkins

  1. Link g1 Rb30e+t leaning out

    in Link G1

    Posted

    Hi,

    I have a link g1 v3 running and rb30e+t.   When transferring from rolling to acceleration, with the smallest amount

    of accelerator pressure the car leans out completely unless you give it more throttle.  Do you know which setting or combination of setting can prevent this ?

     

    Thanks

  3. Dead rb30E+T link g1 v3

    in Link G1

    Posted

    Have a link G1 V3 in a VL rb30e+t was running good

    did an engine swap It cranked first go drove around for 15 minutes then cruising

    at 100 it just died. still cranks but no spark.  full tank of gas. 

    Is it normal for spark plug to spark once when key is moved from off to on (not  start)

    tried a different CAS that's known working and no luck

    Any suggestions what else to try ?

  4. 30et to 30det

    in Link G1

    Posted

    Hey wondering if a Link G1 V3  B42V3  will be able to be converted to use on a 25det head rb30.
    From what ive read itll need a multi coil igniter but im wondering if the crank angle sensor from the 30e head

    wont be putting out the same trigger signals as the DET head CAS ?


    cheers


    Matt 

  7. Unknown problem

    in Link G1

    Posted

    Hi, ive got a link G1 V3.   I wired in the link and got it running, did about 100kms with it no problems and now it will start for about 5-10 seconds then die and when i try to start again the RPM value shows 000 so im assuming it stops getting a trigger signal ?

    Any tips on where to go from here ?

    Cheers
     

  8. Link G1 V3 Circuit diagram

    in Link G1

    Posted

    Unsure, its the resistor between the Ignition 3 connector plug and the transistor,  ive added a picture which should clear it up.  It's where ive put the white 10R resistor.  So now assuming my guess was wrong and should replace it with a 22R ?

    Cheers

  9. Link G1 V3 Circuit diagram

    in Link G1

    Posted

    Hi mate, 

    Ive got what i think is a Link G1 V3.    Sticker on the chip says  B42V3    201000

    And the board has a sticker that says  9709   S/N  314527

    Is it possible to get a circuit diagram for the board or if there is a guru that would know what the resisotor value is of the first

    resistor in line with the Ignition 3 input i have managed to roast it.  

    Cheers

  12. CAS Wires

    in Link G1

    Posted

    Hey there closing stages of wiring in a LINK V3.   Do you know which wires from the VL RB30E  CAS  are used for Trigger 1 and 2 ?   The CAS has an earth, 12v, yellow and a white.  Dont know which of the yellow or white to use for Trigger 1 and if Trigger 2 is needed at all.  


    Cheers.

  13. V3 RB30E + T

    in Link G1

    Posted

    Hello, about to attempt wiring in a Link V3 to a holden RB30E to which i have added a turbo.  Am wondering if i will need

    the link ECU igniter module or can run my factory igniter no problems?

    thanks

×
×
  • Create New...