[CAL table for innovate mtx ?]

I got them close but if i am going to use the closed loop i think i might just the bullet and buy can link and expansion plug.

 

[CAL table for innovate mtx ?]

13 hours ago, Adamw said:

You will have to do something custom yourself, the analog output on those are total crap.  The best you can do is use LM Programer to set the mtx so it outputs just a flat line say 0.5V, note the voltage received in ECU software, then do the same at full scale, say 4.5V, you will then have 2 known voltage points to calibrate between.

you are not wrong,such a nonsense,i did monitor ecu input voltage from WB whilst looking at the gauge so i have some numbers which should get me close.  

[CAL table for innovate mtx ?]

Any body have one they can share mine is off by a fair bit(the stock innovate cal table)

i have earthed sensor to engine etc but not good enough.

 

always 0.5 out

 

Thanks in advance

 

Andy

[Bmw 328 triggers on 325 link?]

I have wired in a hall m50 vanos cam sensor and now have 2 triggers and rpm.

 

hooray!!

only prob now is the popping and banging and trying to run backwards,

must be firing order or injector wiring i guess

[Bmw 328 triggers on 325 link?]

Right by fitting m50 crank sensor (sync off) i have rpm

i need to get the cam working though for Sequential

ive fitted a m50 cam sensor but have no voltage or signal.

is there a possibility the cams have a different trigger Wheel

 

ive even wired the crank into trig 2 and have signal yes to test circuit.

 

thanks

 

andy

[Bmw 328 triggers on 325 link?]

Im using the m52 pin out

[Bmw 328 triggers on 325 link?]

Right fitted m50 (inductive) 325 crank sensor.

wired brown trigger +ve.       Pin 1

yellow -ve(sensor ground).    Pin2

red yellow shield(shield ground). Pin 3

set reluctor in trigger 1 

60-2

level low.

 

still no rpm swapped +ve and -ve nothing

did have trigger yes on signal once but no rpm

have 2-3 volts ac across brown and yellow whilst cranking

It did seem odd though that when i connect -ve wire to ecu sig ground i lose the 2-3 volt ac

 

please help

 

thanks

 

andy

[Bmw 328 triggers on 325 link?]

Swapped to m50 vr sensor,wired as per link help sheet,trigger 1/-ve/shield

changed settings to reluctor 60-2

still no rpm reading on pc link,am i missing something

or not done somethimg really simple

 

thanks again

 

andy

[Bmw 328 triggers on 325 link?]

Hello all

 

ive recently fitted a link g4 to a customers 328 E36

i have ect/tps/map/iat etc working but cant get rpm signal

as far as i can see on the diagrams the 325(m50 with bosch ecu)

uses vr(inductive/normal)crank sensors

however the 328(m52 with siemens) seem to use some hybrid hall/vr 5v sensor

i have tried all sorts to get it running in trigger settings but no rpm signal(car ran on stock ms41 m52 ecu)

from what i can make out according to bmw and autodata i have

red/yellow 5v live

yellow signal wire

and a brown -ve

any body come across this before?

am i better off fitting a m50/325 vr sensor?

thanks

Please help

andy