Jump to content

Matt Holmes

Members
 View Profile  See their activity

  • Posts

    7

  • Joined

  • Last visited

    Never

 Content Type 

Posts posted by Matt Holmes

  1. 6 Row Tuning

    in Link G1

    Posted

    I have an older V3 Link G1 and I am now converting my ignition timing vales into a new computer with 12 zones instead of six. I was wondering where the numbers shown for each zone correspond to. FOr example, if the tuning module shows 30 degrees for zone 3 (80-120 kPa), do I have 30 degrees at 80 kPa, 120 kPa, or perhaps in the middle of the zone (100 kPa)? The zones are so broad that the timing values can vary quite a bit depending on how I interprett where in the zone my numbers apply to. -Matt

  2. Link G1 LEM CLosed Loop Lambda Control

    in Link G1

    Posted

    What type of o2 sensor should I use to autotune my ECU. Also, I have the handheld controller and just need to know how to wire the o2 up. I have a five wire Bosch LSU 4.2 I use with my LM-1 but the manual shows a schematic for a three wire o2. (Two for the heater and one input to the white harness wire). Please explain.

  4. Start Up Settings

    in Link G1

    Posted

    My engine is tuned fairly well but there is one glich as I start it. The motor will sputter a bit and usually shut down unless I press on the accelerator a bit. When I do this the motor will sputter less and less until after 10-20 seconds the idle smooths out and everything is fine. It acts identical to a carb motor that has been slightly flooded. It's almost as if if dumps fuel in when I turn the ignition on and then I have to clear it out by opening the throttle for a bit. I have a pre link plus G1 with a hand held controller. I suspect either my crank fuel or 100 & 105 zones are off but tinkering with them didn't seem to get me anywhere. The clmap setting is at about 35 kpa. Any ideas? Also, this might be a dumb question but do higher crank fuel numbers mean more or less fuel? RIght now mine is set to about 40. Thanks, -Matt

  6. New Injectors on sti motor

    in Link G1

    Posted

    I should clarify that I have a pre LinkPlus model (not sure which exact version) with a master fuel and zone fuel range of 0-99. I noticed through this forum that the Link-Plus units have settings from 0-255. I am upgrading the injectors because I will be upping the boost and was close to maxing the injectors out as it was.

  7. New Injectors on sti motor

    in Link G1

    Posted

    I have the motor tuned pretty good with a master fuel setting of 34 and the zone fuel numbers varying between 40-50. I am upgrading my injectors from 490cc to 788cc. I have a tuning module and a wideband datalogger but am looking for a little guidance on where to start. Any ideas on how much lower I should set the master fuel so that I'm not running way too rich to begin with?

×
×
  • Create New...