[AIM Dash, VIPEC CAN_BUS_FULL.LCC]

Hi Daniel.

I've duplicated the old "Vipec CAN Bus full stream" as best I can without having a dash here to test with.  There are a few parameters that I dont have a good record of what AIM expects and also there are a few parameters that we have changed over time that may need the scaling tweaking.  So please give it a try and report back what works and what doesn't - or if if doesn't work at all and I will see what I can do.  Grab the .lcs from here: Vipec Full Test.lcs
Set up the mode tab like below, then load stream in to stream 1:

 

 

 

 

 

Adam i have got this setup working with most success on my vipec i88 wire in and aim dash. The only thing i that dosnt work is the EGT which i have assigned to AN Volt 2... the display on the dash reads nothing at idol then when you accelerate it flashes some numbers like 1000 ect. Maby there is some mismatch in the can config as the ecu itself displays egt prefectly on the computer.

[AIM Dash, VIPEC CAN_BUS_FULL.LCC]

i emailed aim about this and they responded that it is hard programed into RS3 and cannot be displayed. or handed out as a separate document.

[G4+ Shift Cut Switch]

There is not currently any lockout to disable gear shift control by the driver. I can ask the engineers to consider adding this.

Scott

Thanks mate it would be much appreciated by us Drift guys and im sure the Rally guys wouldn't mind it also for gravel.

[Another Can Question. G4+ AIM MXL STRADA]

Thanks Scott ill see if i can get some info out of AIM...

In the aim setup file there is an option for G4 Rather than GENERIC CAN... this has the ability to use the AN volt Chanel.

Is there a way we can configure the G4+ to transmit on these streams.

[Another Can Question. G4+ AIM MXL STRADA]

Gents I need some help with adding some more Channels to My Aim MXL STRADA Dash. There is a lot of information being fed into the ECU and i need to display more on the dash.

The Generic dash base can profile has no allowance for things like Exhaust Gas Temps And NOS Pressure which we have setup to an AN Volt Channel.

I cannot work out how to do this through the AIM Race Studio OR The Link Software.

FYI the dash is working with the channels that are already provided just i would like to add 2 more.

[G4+ Shift Cut Switch]

Gents we have setup shift cut with the TTI Sequential Gear Barrel POT. Due to this being a drift car we need to be able to turn the shift cut on and off via a switch in the cab.

 

I have thought about using a switch to turn off the gear barrel AN Volt input but this will turn off the gear display and as this car is fitted with NOS i don't want it spraying in 1st or second gear.

I there another way we can do this and if not available is there a way it can be added into the firm where.