azmak
Members-
Posts
69 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Everything posted by azmak
-
まず、パソコンを「USB⇒」に接続しました。 AIMMXLを「CAN/RS232」に接続しました。 その場合、PC〜LINKECU〜AIMは同時に接続できませんでした。 AIMMXLを「CAN/RS232」に接続しました。 PCを「CAN2/OBD」に接続しましたが、通信できませんでした。 正しく接続する方法を教えてください。
-
Thank you very much.
-
Hello everyone. It is Honda Civic B16 turbo. LINK G4 + MONSOON is used. I need a base map. Ignition method remains as it is. (Distributor ignition method) I am waiting for good news. Thank you very much.
-
Thank you for your explanations.
-
That was really helpful. Thanks a lot.
-
Hello everyone. Key ON tachometer sweep method. I do not know how to do it. Is the current setting incorrect? It is 350Z G4 + plug-in. Best regards
-
350 Z after September 2004 will not function. My 350Z in 2003. Currently Stoich Mode (Narrow Band) is working at stock O2 sensors.
-
Hello everyone. 350 Z Stoich Mode (Narrow Band) Closed Loop Lambda reflects which signal of AN Volt 10 - O2 Sig RF or AN Volt 11 - O2 Sig LF? Right side? Left side ? Or both? The set values of AN Volt 10 - O2 Sig RF and AN Volt 11 - O2 Sig LF remain the default of the 350 Z base map. Best regards
-
I thought by looking at the wiring diagram, but I could not understand it. Please tell me in detail. Please also tell me about software settings. I’m at a loss of what to do.
-
I drilled a hole in the side. The front becomes an obstacle to opening and closing the case.
-
I am very grateful to you. I'll give it a try.
-
Please tell me the way of terminal and connection.
-
I inserted a 350 Z plug-in. SLIP and VDC light up. This is a non-functional state. VDC ON / OFF switch does not respond. Please tell me the method of recovery.